CONDOR
Power Supply
Compact
PCI Power Supply
200 Watt, AC Input
Model
# CPCI 204-1203
FEATURES:
- Fully compliant with
PICMG(R) CompactPCI(R) specifications
- Current sharing and
internal OR-ing diodes for N + 1 redundancy
- High current 5 V and 3.3 V
outputs
- CompactPCI(R) package
requires only 15 cfm of external cooling air
Specifications:
-INPUT-
Voltage/Current
.............. 90-264 Vac continuous range, 47 to 63 Hz
Power Factor
..................0.99 typical at full load.
serviceable.
Meets EN61000-3-2 Class A.
Inrush Current
................ Cold start ac current is less than 27 A at 115 Vac,
and 50 A at 230 Vac. Limited by thermistor.
Brownout Protection
.......Holds regulation to 85 Vac
(30
seconds maximum)
Holdup Time
...................10 ms minimum after removal of power at full load.
Efficiency.......................70%
typical.
EMI: Conducted RFI
.......Meets FCC Part 15, Class A; EN55022 Class A
FAIL#
Signal...................TTL compatible signal. Signal goes low
under
the following conditions: Outputs #1 or #2 fail;
an overcurrent condition on outputs #1, #2, or
#3; an overtemperature shutdown; an
overvoltage shutdown; or an ac input failure (5
ms
warning before outputs shutdown).
-OUTPUTS-
Model
|
V/A V1
|
V2
|
V3
|
V4
|
CPCI-204-1203
|
5.0/25
|
3.3/30
|
+12/5.5
|
- 12/0.5
|
Line & Load Regulation
. ± 2% over input range and minimum to 100% load change.
Ripple &
Noise................ 1% p-p or 50 mV, whichever is
greater. Measured at mating connector with 20 µF
Remote Sense
...............Open sense lead protection
warm-up.
Temp. Coefficient
..........(Outputs #1 and 2): 0.03% per degree centigrade
Stability...........................
0.1% over 8 hours after 30 minutes warm-up.
Transient Response......
(Outputs #1 and 2): Output voltage returns to within 1% in less
than 1 ms for a 50% load change. Peak transient does not exceed 5%.
Overvoltage
Protection......................
(Outputs #1 and #2): Protects load against power supplyinduced
overvoltage. Trip-point is factory set so that output voltage cannot
exceed 136% of nominal. Input power must be recycled to reset.
Overload
Protection......................
All outputs are protected against overload and short circuit, Automatic
recovery upon removal of fault.
DEG#
Signal.................. TTL compatible signal. Signal goes low
20ºC before an overtemperature shutdown.
Protection.......................
Internal temperature sensing. Causes all outputs
to shut down. Automatic recovery.
DEG#
Signal................... TTL compatible signal. Signal goes low
20ºC before an overtemperature shutdown.
Fail
LED..........................Amber LED illuminates upon a failure
condition as per the CPCI and DPCI series specifications.
Status
LED.....................Green LED illuminates with no presence of any
failure condition.
Remote
Enable................Contact closure to common turns on
dc outputs.
outputs. Recessed pin for “make last, break first” connection.
Remote
Inhibit.................Contact closure to the negative sense line or a
TTL level “0” turns off dc outputs.
Redundancy..................Built-in
ORing diodes, slope program current sharing on all outputs, and self
aligning connector provide hot swap and N+1output rating while units
are in thermal equilibrium. capabilities. Current sharing remains
within 10% of the unit’s full
Reverse
Voltage............Protected against reverse voltage up to supply
current rating. except for reverse voltage on output #4 on CPCI-200.
-ENVIRONMENT-
Cooling
...........................200 Watt: 15 cfm, 225 lfm airflow required
for cooling.
Output
Isolation...............Isolated from ground 50 Vdc (leakage current
<20 µA)
Thermal
Protection..........Shuts down power supply if overheated.
Automatic recovery.
Temperature Range........0
to 40º centigrade at full ratings; derate 2.5% per degree
centigrade
from 40º to 70º centigrade. Unit will start up at
-20º centigrade.
-INTERCONNECT-
Connector: Positronics
PCI47M400A1Connectors.
Mating Connector:
PCIH47F300A1
-MECHANICAL-
Outline............................3U
x 8HP front panel. Complies with all current PICMG ® CompactPCI PSU
specifications.
-SAFETY AGENCY APPROVALS-
All
Models.......................Models are approved to UL1950; CSA 22.2
#234; IEC 950 and TUV EN60950, Class 1 SELV., CE
72/23/EEC/93/68EEC (low voltage directive).
|